Short answer: a rotten-egg smell in well water is almost always hydrogen sulphide gas. Most often it comes from sulphate-reducing bacteria living in the well or plumbing, so shock chlorinating the well is usually the first thing to try. If the smell is only in your hot water, the cause is likely your water heater, not your well.
What causes the rotten-egg smell?
Hydrogen sulphide (H2S) is a dissolved gas. Alberta Agriculture notes it can occur naturally in groundwater or be produced by sulphate-reducing bacteria, and that bacteria are the most common cause. These bacteria feed on natural sulphate in groundwater and give off small amounts of the gas.
You do not need much of it to notice. Alberta Agriculture says H2S can cause odour problems at levels as low as 0.05 mg/L in well water.
Hot water only, or hot and cold?
This one check narrows it down fast. After you have been away for a few hours, smell the water from a hot tap and then a cold tap.
| What you notice | Likely cause | What to do |
|---|---|---|
| Smell in hot water only | Reaction inside the water heater, often involving the magnesium anode rod | Have the anode rod replaced and the tank disinfected or flushed |
| Smell in hot and cold, strongest when first turned on, then fades | Sulphur bacteria in the well or plumbing | Shock chlorinate the well, then retest |
| Strong, steady smell in hot and cold | Hydrogen sulphide in the groundwater itself | A sulphur filter, such as an air injection catalytic carbon system |
Is it safe to drink?
In most cases the smell is a nuisance rather than a health problem. Health agencies still recommend testing for coliform bacteria and nitrate, because in rare cases the gas can come from sewage or other contamination.
In Alberta, private well owners can have their drinking water tested through Alberta Health Services. Along with bacteria, rural residents can have their water tested for nitrates, fluoride, iron and sodium. Contact AHS Environmental Public Health to find out where to pick up and drop off sample bottles.
What hydrogen sulphide does to your home
- Corrodes plumbing and fixtures
- Turns silverware and sterling silver black
- Can leave black stains and make water look dark
- Makes the whole house smell, especially when running hot water
How to get rid of the smell
1. Shock chlorinate the well
Since bacteria are the most common cause, Alberta Agriculture recommends treating them first, and shock chlorination is the standard way to control sulphate-reducing and iron bacteria in a well. The smell can return over time, so some homes need this done periodically.
2. Fix the water heater
If only the hot water smells, replacing the magnesium anode rod with a different type and disinfecting the tank often solves it. Unless you know water heaters well, have a plumber or water treatment professional do this.
3. Install a sulphur filter
When the gas is in the groundwater itself, a filter is the long-term fix. Our air injection sulphur filter uses a pocket of air to oxidize the hydrogen sulphide and catalytic carbon to remove it, then backwashes itself clean on a schedule, with no chemicals to add.
Test before you buy
Start with a hydrogen sulphide test to confirm the cause, or book a free water test. Hydrogen sulphide escapes from water quickly, so testing on site gives the most reliable answer. If you also see orange or black staining, iron or manganese may be involved too; see our water odour guide.
Frequently asked questions
Why did the smell start after I installed a water softener?
Occasionally, sulphate-reducing bacteria can grow inside treatment equipment such as a softener. Disinfecting the system usually clears it up.
Can I just run the water until the smell goes away?
If the smell fades after running the water, that points to bacteria in the well or plumbing. Running the tap is a short-term workaround; shock chlorination deals with the cause.
Is it safe to go into my well pit to check?
No. Hydrogen sulphide and other gases can build up in enclosed spaces like well pits. Leave inspections to a qualified well or water treatment professional.
Sources: Alberta Agriculture, Removing Hydrogen Sulphide from Water (Agdex 716-D14); Government of Alberta, Working Well; Alberta Health Services, private drinking water testing; Minnesota Department of Health; Penn State Extension.

