,

How Often Should You Change RO Filters?

How Often Should You Change RO Filters?

Short answer: change the sediment and carbon pre-filters and the post-filter about once a year, and the RO membrane every 2 to 3 years. Change them sooner if your water starts to taste different, the faucet slows down, or the tank takes longer to refill. Calgary’s hard water can shorten that schedule, so treat it as a maximum, not a target.

Replacement schedule at a glance

StageWhat it doesWhen to change
Sediment pre-filterTraps sand, rust and particlesEvery 12 months, or sooner if flow drops
Carbon pre-filter(s)Removes chlorine, which damages the membraneEvery 12 months
RO membraneRemoves most dissolved solidsEvery 2 to 3 years, or when water quality drops
Post-filter (carbon)Polishes taste before the faucetEvery 12 months
Alkaline filter (if you have one)Adds minerals back and raises pHAbout every 12 months

Why the pre-filters matter most

The pre-filters protect the membrane, which is the most expensive part. If the carbon pre-filter is used up, chlorine reaches the membrane and wears it out early. If the sediment filter clogs, flow and pressure drop. Changing the inexpensive pre-filters on time is what makes a membrane last its full 2 to 3 years.

Signs it is time to change filters

  • Water tastes or smells different, especially a chlorine taste returning
  • The RO faucet flows slower than it used to
  • The storage tank takes much longer to refill
  • Spots or film return on glasses rinsed with RO water
  • It has been a year since the last change (write the date on the filter)

A handheld TDS meter is a cheap way to check the membrane. If your RO water’s TDS reading creeps up over time, the membrane is wearing out.

Filters for the systems we sell

SystemYearly filtersMembrane
PureValue 5-Stage, 50 GPDPureValue Annual Filter SetPureValue 50 GPD Membrane
GR/O Water Saver, 75 GPDGR/O Pre-Filter SetGR/O 75 GPD High-Recovery Membrane (use the matching flow restrictor)
FreshPoint 4-Stage, 75 GPDFreshPoint Annual Filter SetFreshPoint 75 GPD Membrane

Have a different brand? Send us a photo of your system and we will match the filters.

How a filter change works

  1. Turn off the cold water feed to the RO system and close the valve on top of the storage tank.
  2. Open the RO faucet to release pressure.
  3. Remove the old cartridges (twist-off or click-in, depending on the system) and install the new ones.
  4. Turn the water and tank valve back on and check for leaks.
  5. Flush the new filters as the manufacturer directs, usually by running the faucet and draining the first tank of water.

Always follow the instructions for your specific system. If you would rather not do it yourself, we can change filters for you in Calgary and the surrounding area.

Frequently asked questions

What happens if I never change my RO filters?

Flow slows, taste gets worse, and chlorine can reach and damage the membrane. Eventually the system stops removing what you bought it to remove.

Can I change just the membrane?

Change the pre-filters at the same time. Putting a new membrane behind worn-out pre-filters shortens its life.

Does hard water affect RO filters?

It can. Hard water puts more load on the membrane, which is one reason to stay on schedule in Calgary. Some homes pair RO with a water softener.

Get your water tested for free

AllWaterFix tests your water at your home or business in Calgary and area, explains the results and recommends only what you need. Call (587) 842-2824, Monday to Friday, 9am to 5pm.


Last updated: